Vddmem Power Jumper (P10); Vddflash Power Jumper (P11) - Analog Devices EZ-Board ADSP-BF518F Manual

Jumpers

VDDMEM Power Jumper (P10)

The VDDMEM power jumper (
current supplied to the memory interface of the processor. By default,
is , and the power flows through the two-pin IDC header. To measure
ON
power, remove
voltage is measured, power can be calculated. For more information, refer
to "Power Measurements" on page

VDDFLASH Power Jumper (P11)

The VDDFLASH power jumper (
and current supplied to the processor core.
power flows through the two-pin IDC header. To measure power, remove
and measure voltage across the 0.1 ohm resistor. Once voltage is mea-
P11
sured, power can be calculated. For more information, refer to
Measurements" on page
2-20
P10
and measure voltage across the 0.1 ohm resistor. Once
P10
1-24.
ADSP-BF518F EZ-Board Evaluation System Manual
) is used to measure the voltage and
1-24.
) is used to measure the flash voltage
P11
is
P11 ON
P10
by default, and the
"Power