Flash Wp Jumper (Jp3); Adc Range Jumper (Jp4); Led Select Jumpers (Jp11-12); Ethernet Power Down Jumper (Jp13) - Analog Devices EZ-Board ADSP-BF518F Manual

Flash WP Jumper (JP3)

The flash WP jumper (
lel flash chip. Block 70 contains 64 KB of configuration data at address
range
0x203 F0000—0x203 FFFFF
and the parallel flash driver from Analog Devices is used, block 70 is
read-only. By default,

ADC Range Jumper (JP4)

The ADC range jumper
to the ADC. The jumper determines whether the input range for the ADC
is 2.5V or 5 V. The max voltage range for a signal connected to the SMA
connector is 0–5V. Any voltage outside of this range can damage the
EZ-Board. By default,
LED Select Jumpers (JP11–12)
The LED select jumpers (
net status is reported on the LEDs. By default,
is not installed. The LEDs can be used to report the status of the link,
activity on the line, duplex mode speed, and collisions. For more informa-
tion about the LEDs, refer to the KSZ8893M data sheet provided by the
product manufacturer.

Ethernet Power Down Jumper (JP13)

The Ethernet power down jumper (
PHY into a power down mode. In this mode, the entire chip is powered
down, and the register configuration is not saved. By default,
installed.
ADSP-BF518F EZ-Board Evaluation System Manual
ADSP-BF518F EZ-Board Hardware Reference
) is used to write-protect block 70 of the paral-
JP3
. When the jumper is installed on
is installed.
JP3
is used to select the range of the input signal
JP4
is installed.
JP4
and
JP11 JP12
JP13
) are used to configure how Ether-
is installed, and
JP11
) is used to put the KSZ8893M
,
JP3
JP12
is not
JP13
2-17