Channel:state? <Nr1; Output[:State][:All] <Bool>,(@Chanlist) - ITech IT-M3100D Programming Manual

Query command
INSTrument[:SELect]?
Returns
NR1
CHANnel:STATe? <NR1>
This command is used to query the device status of the specified channel.
Syntax
CHANnel:STATe? <NR1>
Parameters
1-16 channel number
Default value
Not applicable
Example
CHANnel:STATe? 1
Returns
0|1
0: Indicates that the device corresponding to the specified channel number
does not exist;
1: Indicates that the device of the specified channel exists.
OUTPut[:STATe][:ALL] <bool>,(@Chanlist)
This command is used to set the output on or off in multi-channel mode.
The commands in this programming guide all support single-channel or
multi-channel selection in the form of @Chanlist.
Take OUTPut[:STATe][:ALL] <bool>,(@Chanlist) as an example, OUTP
1,(@1,8) means to turn on the output of channel 1 and channel 8; OUTP
1,(@1:8) means to turn on the output of 8 channels in total from channel 1 to
channel 8; OUTP 1,(@1,8,10) means to turn on the output of 3 channels in total,
channel 1, channel 8, and channel 10.
Supports up to 2 commas separated, such as OUTP 1,(@1,8,10) ; OUTP
1,(@1,3:8,10)
Copyright © Itech Electronic Co., Ltd.
Channel Selection Commands
5