Installation Hardware - Will Burt 7-30 HDL Operating Instructions Manual

5.3

Installation Hardware

This section describes hardware that may be used during installation as follows:
• Table 5-2 Hardware for Internal Mount Application Installation
• Table 5-3 Hardware for External Mount Application Installation
• Table 5-4 Hardware for Ultra Heavy Duty Installation
Table 5-2 Hardware for Internal Mount Application Installation
Hardware*
Internal Mounting Kit (To the Roof)
¼ Inch (M6) Bolts
¼ Inch (M6) Lock Washers
¼ Inch (M6) Nuts
Non-Rotatable Base Plate (To the Mast)
(4) ⅜-16x1 Flathead Screws
(P/N: 2772)
Non-Rotatable and Rotatable Base Plate (To the Mounting Surface)
(4) ⅜-16x1-½ Inch Bolts
(P/N: 901594)
(4) Flat Washers (P/N: 2054)
(4) Lock Washers (P/N: 0801)
(4) Nuts (P/N: 901593)
TP-5580101-A
FEBRUARY 2022
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
Supplied By
Customer Internal mounting kits for 6.75, 9.0, and
11.25 inch base tubes require eight sets
Customer
of hardware. Internal mounting kits for 5.0
inch base tubes require six sets of
hardware.
The bolts should be sized to length to
allow for the thickness of the internal
Customer
mounting kit, lock washer, nut, roof, and
any spacers.
Found in the Hardware Bag
The Will-Burt
Company
Found in the Hardware Bag
The Will-Burt
Company
Found in the Hardware Bag
The Will-Burt
Company
Found in the Hardware Bag
The Will-Burt
Company
Found in the Hardware Bag
The Will-Burt
Company
OPERATING INSTRUCTIONS
Notes
PAGE 73 OF 164