Connect The Air Supply To The Control Box - Will Burt 7-30 HDL Operating Instructions Manual

5.8.2.4

Connect the Air Supply to the Control Box

To connect the air supply to the control box:
1. Route a ⅜ inch air hose from the air supply to the control box. A filter regulator lubricator or
filter lubricator can be run in-line between the air supply and the control box. If routing the air
hose through a structure, The Will-Burt Company recommends the use of a grommet or
equivalent to protect the air hose.
Note: If the system shipped with a 12 mm hose (P/N: 5825901, P/N: 5826001, P/N: 5826101,
or P/N: 5826201), remove the 3/8 hose fitting from the air inlet on the control box and replace
it with the 12 mm hose that is supplied with the system. Not all systems ship with a 12 mm
hose.
2. Connect the air supply to the control box through the "AIR IN" push connect (Figure 5-22).
Air Supply
Connects Here
TP-5580101-A
FEBRUARY 2022
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
Figure 5-22 Control Box "AIR IN" Connection
OPERATING INSTRUCTIONS
PAGE 113 OF 164