5.10 Install The Magnetic Warning Kit - Will Burt 7-30 HDL Operating Instructions Manual

5.10 Install the Magnetic Warning Kit

When installing the mast system on a vehicle, the magnetic warning kit shall be installed to
provide a warning against moving the vehicle while the mast is partially or fully extended. When
correctly installed, flashing lights will indicate partial or full extension of the mast when the ignition
is on. When the mast is properly nested, or the ignition is off, the lights will cease to illuminate.
The lead to the positive battery terminal should be connected to the ignition switch so the lights
will only illuminate when the mast is extended and the ignition is on. The operator should always
visually confirm that the mast is entirely retracted before moving the vehicle. Be certain to
observe any local codes or regulations.
To install the magnetic warning kit:
1. Tie one end of a piece of rope or wire to the top of the magnet through the eyebolt (Figure 5-
30).
2. Carefully lower the magnet into the top of the top tube.
3. Using the rope, lower the magnet to the bottom of the top tube. It is important that the magnet
is resting on the bottom end of the top tube. Cut off the excess rope.
4. Assemble the magnetic switch assembly and the stainless steel band.
TP-5580101-A
FEBRUARY 2022
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
Attach Rope
Here
Figure 5-30 Magnet
OPERATING INSTRUCTIONS
PAGE 121 OF 164