Section 4
This section provides instructions for installing the Hurry-Up® Mast and provides the general
procedures that must be followed to ensure a successful installation. Be sure to read and
understand the entire installation procedure and the Safety Summary (Section 1) before
beginning installation.
4.1 Pre-Installation Check
Before installing the mast system, ensure:
•
All installers read and understand the entire installation procedure.
•
Only a properly trained and qualified certified electrician performs electric installations
and maintenance.
•
The mounting structure is level and has sufficient room and strength to mount the mast
system.
•
All purchased components are included (Section 2.4).
•
All required equipment is readily available (Section 4.2).
•
When installing in a vehicle, ensure that the vehicle is stationary and on a level surface.
4.2 Recommended Installation Tools
Table 4-1 lists recommended tools and materials for installation.
Wrenches
Safety Gloves
Sockets
Hoist
Hammer
Drill
Note: Depending on the national and local standards and codes of practice, and the environment, additional
personal protective equipment may be necessary.
TP-5928001-C
February 2023
Installation
Table 4-1 Tools and Materials Required for Installation
Tools and Materials
Screwdrivers
Sling / Strap
String or Thin Wire
Torque Wrench
Level
Loctite® 242/243 (Blue) or
Equivalent
H
-U
® M
O
URRY
P
AST
PERATOR
Thread Tape
Measuring Tape
Plumb Bob
Safety Glasses
Saw
Pipe Thread Sealant or PTFE Tape
'
M
S
ANUAL
4-1