Position The Mast; Secure The Base Plate To The Mounting Surface - Will Burt 7-30 HDL Operating Instructions Manual

Rotatable Base Plates
To install a rotatable base plate:
1. Back the locking screws far enough out of the base plate to allow the base plate to fit over the
end of the mast.
2. Slide the base plate over end of the mast.
3. Tighten down the locking screws to secure the base plate to the mast.
5.7.2.5

Position the Mast

To position the mast:
1. Lower the mast the rest of the way to the floor.
2. Carefully, move the mast into position ensuring the mast is level. It is necessary to check the
mast in two places 90° apart when leveling. Be certain to orient the mast so the operator has
a clear view of the hazard labels.
Note: Additional labels are provided with the operator's manual and should be installed where
the operator will have a clear view of them while operating the mast.
5.7.2.6

Secure the Base Plate to the Mounting Surface

To secure the base plate to the mounting surface:
1. Use the base plate as a template to drill holes through the mounting surface.
2. Ensure the base plate and mast are level in all directions. It is necessary to check the mast in
two places 90° apart when leveling.
3. Secure the base plate to the mounting surface with appropriate hardware. To secure the base
plate, the hardware bag contains:
a. (4) ⅜-16x1-½ Inch Bolts (P/N: 901594)
b. (4) Flat Washers (P/N: 2054)
c. (4) Lock Washers (P/N: 0801)
d. (4) Nuts (P/N: 901593)
Depending on the customer-specific mounting application, other (customer-supplied)
hardware may be required. The mounting hardware must include proper means to resist
vibration loosening such as thread-locking compound or locking hardware. Torque to 15.83-
20 ft.-lb. (21-27 Nm).
TP-5580101-A
FEBRUARY 2022
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
PAGE 103 OF 164