Installation Equipment - Will Burt 7-30 HDL Operating Instructions Manual

PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
5.2

Installation Equipment

Table 5-1 lists general equipment recommended for installation. Depending on the mast system
configuration, additional equipment may be required.
Table 5-1 Equipment Recommended for Installation
Personal Protective
Safety Glasses
Hard Hat or Helmet
Hand Tools
Wrenches
Torque Wrench
Plumb-Bob
Rubber Mallet
Sockets
Hex Wrenches
Equipment
Compressed Air Supply
Expendables
Pipe Thread Sealant or
PTFE Tape
®
Loctite 242/243 (Blue) or
Equivalent
*Note:
• Depending on the local, regional, and national standards and codes of practice, and the environment,
additional personal protective equipment may be necessary.
• Depending on the mast system configuration, additional equipment, including but not limited to, rubber
washers or grommets (for the pneumatic system), electrical components (e.g. wire, fuses, circuit breakers,
etc.), and air control valves, switches, air hose and fittings, may be required.
• When disposing of any disposables or components, do so according to any applicable local, regional, and
national standards and codes of practice.
PAGE 72 OF 164
Recommended Equipment*
Work Gloves
Hearing Protection
Screwdrivers
Drill
Measuring Tape
Rope or Thin Wire
Appropriate Hardware
(Section 5.3)
Hoist
Rags (Clean and Dry)
Soapy Water
(When installing the weather bonnet)
Safety Shoes
Nitrile or Vinyl Gloves
Hammer
Saw
Level
Washers or Spacers (For shimming)
16 AWG Stranded Wire (For the
Magnetic Warning Kit)
Sling / Strap
Silicone Sealant
FEBRUARY 2022
TP-5580101-A