Connect The Control Box To The Mast - Will Burt 7-30 HDL Operating Instructions Manual

PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
5.8.2.5

Connect the Control Box to the Mast

To connect the control box to the mast:
1. Remove the RLS Guard.
2. Connect the ⅜ inch air hose (P/N: 108768) to the "MAST" connection on the control box
(Figure 5-23).
Sensor Cable
Connection
3. Route the air hose (P/N: 108768) to the base of the mast. If routing the air hose through a
structure, The Will-Burt Company recommends the use of a grommet or equivalent to protect
the air hose.
4. As necessary, trim the air hose to the desired length.
5. Connect the air hose (P/N: 108768) to the drain and relief fittings. The air hose will use a
close nipple, part of the hardware bag (Section 3.3.1.1), to connect to the brass cross. Apply
PTFE Tape to all threaded joints.
6. Connect the ¼ inch air hose (P/N: 5558001) to the "LOCKS" connection on the control box
(Figure 5-23).
7. Route the air hose (P/N: 5558001) to the mast so that it can reach the locks. If routing the air
hose through a structure, The Will-Burt Company recommends the use of a grommet or
equivalent to protect the air hose.
8. As necessary, trim the air hose to the desired length.
9. Each mast lock has an air hose that runs from the lock to a "T". Connect the air hose from the
control box to the "T".
PAGE 114 OF 164
Figure 5-23 Control Box to Mast Connections
⅜ Inch Air Hose
to Mast Base Tube
Connection
¼ Inch Air Hose to
Locks Connection
TP-5580101-A
FEBRUARY 2022