Connect Customer Power To The Control Box - Will Burt 7-30 HDL Operating Instructions Manual

PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
OPERATING INSTRUCTIONS
5.8.2.8

Connect Customer Power to the Control Box

The control box does not have a master power switch. If a master power switch is desired, the
customer must provide it in-line with the customer power. When wiring the customer power, be
certain to observe any local codes or regulations. See Section 10.3 for the system wiring
diagram.
To connect customer power to the control box:
1. Plug 20 gauge power cable (P/N: 5567501) into the "POWER" connection on the control box
(Figure 5-27).
POWER
Connection
2. Route the power cable to the customer power. If routing the power cable through a structure,
The Will-Burt Company recommends the use of a grommet or equivalent to protect the power
cable.
3. Wire the power cable to the customer power.
PAGE 118 OF 164
Figure 5-27 Control Box "POWER" Connection
TP-5580101-A
FEBRUARY 2022