Exhaust The Control Box (Optional) - Will Burt 7-30 HDL Operating Instructions Manual

10. Connect the sensor cable (P/N: 5567601) to the "SENSOR" connection on the control box
(Figure 5-23).
11. Route the sensor cable to the mast so that it can reach the reed switches on the locks. If
routing the sensor cable through a structure, The Will-Burt Company recommends the use of
a grommet or equivalent to protect the sensor cable. It may be possible to use the same
grommet used to route the ¼ inch air hose (P/N: 5558001).
12. Secure the sensor cable to the reed switches.
13. Reinstall the RLS Guard.
Note: The installer may want to wait until the mast has been tested (Section 5.12) before
reinstalling the RLS Guard.
5.8.2.6

Exhaust the Control Box (Optional)

If desired, a ⅜ inch air hose can be add to the "EXHAUST" connection on the control box to route
away moisture (Figure 5-24).
EXHAUST
Connection
TP-5580101-A
FEBRUARY 2022
PNEUMATIC MAST WITH REMOTE LOCKING SYSTEM
Figure 5-24 Control Box "EXHAUST" Connection
OPERATING INSTRUCTIONS
PAGE 115 OF 164