Server Menu - Fujitsu PRIMERGY TX200 S2 User Manual

8.2.12 Server Menu

The [Server] menu sets the server options.
Main Advanced
O/S Boot Timeout:
Action:
Timeout Value:
ASR&R Boot Delay:
Power Cycle Delay:
Boot Retry Counter:
Diagnostic System:
Temperature Monitoring:
Memory Scrubbing:
> CPU Status
> Memory Status
> Console Redirection
> RomPilot
Help
F1
Exit
Esc
Item
O/S Boot Time out
Action
Timeout Value
PhoenixBIOS Setup Utility
Security Server
[Disabled]
[Reset]
[0]
[2]
[5]
[3]
[Disabled]
[Disabled]
[Enabled]
-/+ Change Values
Select Item
Select Menu Enter Select > Sub-Menu
table: Items on the Server Menu
Setting
• Disabled (at the time of
purchase)
• Enabled
• Continue
• Reset (at the time of
purchase)
• Power Cycle
• 0 (at the time of purchase)
• 1–100
PRIMERGY TX200 S2 User's Guide
Exit
Item Specific Help
F9 Setup Defaults
F10 Save and Exit
Description
Sets whether to enable or disable the OS Boot
Monitoring function, when ServerView is installed to
the OS. When this function is enabled, if for some
reason booting the operating system is interrupted,
the system will automatically restart.
The OS Boot Monitoring function can also be
enabled or disabled from ServerView.
Note:
If ServerView is not installed to the OS, be
sure to set to [Disabled]. If the setting is
enabled, the server may automatically turn off
or restart improperly.
Even when ServerView is installed to the OS,
if starting the system while the ServerStart
CD-ROM or DOS floppy disk is inside, be sure
to disable the OS Boot Monitoring function. If
the system is started with this function
enabled, the server may automatically turn off
or restart improperly.
When setting this function, refer to
"ServerView User's Guide" to fully learn about
its specifications, in order to use it properly
with the correct settings.
Sets the operation when the OS did not boot
successfully within the time set with the [Timeout
Value] setting.
Sets the timeout period in minutes.
8
247