Inserting And Ejecting A Floppy Disk - Fujitsu PRIMERGY TX200 S2 User Manual

■ Cautions when Turning the Power Off (When the OS is Windows
Server 2003 or Windows 2000 Server)
• For Windows Server 2003
"Do Nothing", "Prompt Input", "Standby", "Hibernation", or "Shutdown" can be specified as the
operating mode of the power switch in the OS settings (normally, "Shutdown" is specified).
• For Windows 2000 Server
"Standby", "Hibernation", or "Power Off" can be specified as the operating mode of the power switch
in the OS settings (normally, "Power Off" is specified).
On this server, functions corresponding to "Standby" and "Hibernation" are supported as BIOS and
hardware functions. However, some drivers and software installed in the server do not support these
functions. For this reason, functions corresponding to "Standby status" and "Hibernation status" are
unavailable on this server.
When the operating mode is set to "Standby" or "Hibernation", the system may operate improperly or
hard disk data may be corrupted. For details about operating mode settings, refer to the OS manual.

1.4.5 Inserting and Ejecting a Floppy Disk

■ Cautions
When using floppy disks, note the following points to avoid failures:
• Do not expose the disk to any fluids.
• Do not open the shutter of the floppy disk and touch the disk surface.
• Do not bend the floppy disk or place heavy objects on it.
• Do not expose the floppy disk to strong magnetic fields.
• Do not drop the floppy disk on hard surfaces.
• Do not store the disk in extremely hot or cold conditions.
• Do not store the disk in humid or dusty conditions.
• Do not put layers of labels on the floppy disk. Doing so may cause the drive to be clogged with the
disk.
• Keep the disk away from condensation or water droplets.
PRIMERGY TX200 S2 User's Guide
1
37