How To Store The Bios Information - Fujitsu PRIMERGY TX200 S2 User Manual

Chapter 5 Operations after OS Installation

5.3.1 How to Store the BIOS Information

Store the BIOS information according to the following procedures.
Before starting the operation, if the "OS Boot Monitoring" function of ServerView is enabled, disable it
(it is disabled by default).
If you start up the system while the "OS Boot Monitoring" function remains effective, the operation of
the server may become unpredictable at such times as an abrupt power interruption or restart.
If it is necessary to operate the server with the "OS Boot Monitoring" function enabled, enable the
function after storing the BIOS information.
For details of ServerView, refer to "ServerView User's Guide".
You cannot save the set values of the BIOS setup utility in the following location. Write them down
beforehand.
• Information under [Main] menu → [Boot Option] submenu → [Boot Sequence]
1
Turn on the server and insert the "Server Management Tools" disk into the
floppy disk drive.
2
When the DOS promptwindow appears, enter the following command and
press the [Enter] key.
A:\SMTOOL\>biossave.bat
3
If the BIOS information is stored correctly, the following message appears.
Success!
Storing procedure is completed. The server can now be turned off safely.
146
If storing has already been performed with Server Management Tools, the stored file must exist
in the floppy disk. In this case, overwriting the file may lead to incompletion of BIOS information
recovery. Move the file to another floppy disk, rename the file or delete, or it by executing the
following command.
A:\SMTOOL\>deldat.bat [Enter]