Bosch DCI 700 Original Instructions Manual page 4

en | 4 | DCI 700
 Only use test oil complying with ISO 4113-CV-AW. Do
not use or add substances such as diesel fuel or gaso‐
line.
 Change the test oil according to the maintenance in‐
structions.
---
Irritants – Test oil and test oil vapors may cause irrita‐
tion to eyes, skin and respiratory tract.
 Wear protective equipment.
 Ensure proper on-site ventilation and venting of the
work area.
 Do not inhale test oil vapors.
 Do not swallow test oil.
 Do not carry oily rags in your clothes. Remove oily
clothing.
 Clean skin contaminated with oil thoroughly with wa‐
ter and skin-friendly detergent or soap.
---
Risk of injury – Leakage can cause test oil to escape at
high pressure and temperature and may result in per‐
sonal injury.
 Wear protective equipment.
 DCI 700 Use only with complete and functional safety
equipment.
 Never reach into the escaping test oil jet.
 In case of leakage, switch off DCI 700 and wait until
the test oil pressure has decreased. Then eliminate
the leakage.
---
Risk of injury – If there is oil or oil residue on the floor,
there is a risk of accidents and personal injury.
 Remove oil and oil residue on the floor immediately.
 In case of leakage, switch off DCI 700 and wait until
the test oil pressure has decreased. Then eliminate
the leakage.
---
2.2 Warnings and mandatory-action signs
on the product
 All warning signs must be in legible condition.
Read and understand the operating instruc‐
tions before working with the DCI 700.
---
Wear safety goggles when working on the
DCI 700.
---
Wear protective gloves when working on the
DCI 700.
---
Warning – Hot surfaces. Do not touch hot
surfaces.
---
Access prohibited for persons with pacemak‐
ers or implanted defibrillators.
---
Before entering, switch off DCI 700 and dis‐
connect mains plug.
---
1 689 989 473 | 2021-08-24
2.3 Target group
The product may only be used by trained and instruc‐
ted personnel. Apprentices or personnel undergoing
training or instruction may use the product only under
the continual supervision of an experienced person.
Children must be supervised to ensure that they do not
play with the product.
Work on electrical systems or equipment must only be
performed by qualified electricians or trained person‐
nel under the guidance and supervision of an electri‐
cian.
Only personnel with sufficient knowledge and experi‐
ence in hydraulics is allowed to work on hydraulic devi‐
ces.
Instruction on testing diesel components at a Bosch
training center is mandatory.
---
2.4 Other applicable documents
• 1 689 978 630 – assembly instructions DCI 700
• DCI 700 Help Center – online help for DCI 700. Call is
made in the software "DCI" via the button <?>.
---
2.5 Intended use
The common-rail injector test bench DCI 700 (also
called DCI 700) Is used to test the majority of common
rail injectors manufactured by Bosch, Delphi, Denso
und Siemens/VDO/Continental.
Injectors must be tested and measured in accordance
with the instructions. Approved accessories must be
used for adaptation.
The following injectors may be tested with the specially
designed connectors:
• Bosch CRI 1x and CRI 2x
• Bosch CRI piezo (CRI 3x)
• Bosch CRIN with CRI connection features
• Bosch CRIN 1x, CRIN 2x and CRIN 3x (special acces‐
sories required)
• Bosch CRIN 4x (special accessories required)
• Delphi DFI, Denso Gx and Siemens/VDO/Continental
PCR-I (special accessories required)
The DCI 700 is only intended for commercial and not
for private purposes.
Warning! This product may cause high-frequency inter‐
ference in residential environments so that interference
suppression may be necessary.
---Separator---
Robert Bosch GmbH