Table of Contents
Advertisement
10.5
6/1553-ANF 901 54 Uen S2 2016-03-08
Some of the keys have already fixed functions programmed and are not possible to
change by the end-user. After pressing one of the programmable keys the display will
prompt the user to enter a number or a function code:
Figure 68:
In the example above, the selected key has the telephone number 0090510 assigned.
If you want to change the number, enter the new number and press the Save (F4) key.
If you want to delete the last entered character press the Erase (F3) key.
If you want to erase the number assigned to a key: do not enter any number and press
Save (F4).
Press the Exit (F1) key to return to the previous menu.
Note: To be able to program a Dial-by-function key, the telephone normally has to be
logged on to the exchange (this is set by the system administrator).
PROGRAMMING THE RING SIGNAL TYPE ON A LINE OR
MONITORING KEY
It is the system administrator that initiates a Monitoring key. From the telephone you
can change the type of ring signal for the key.
To change the type of ring signal for the Monitoring key, use the navigation keys to
go to the Settings menu and select the Programmable Keys menu by pressing
softkey F4 . Press the wanted Line or Monitoring key and the following menu
appears:
S
ETTINGS
84
Advertisement
Table of Contents
