Mitel MiVoice 4425 IP Vision User Manual page 38

2.16.3
2.16.4
0 = Silent.
1 = Periodic (repetitive) ring signal.
2 = Delayed periodic ring signal.
3 = One muted ring signal. Only one ring signal is generated with a low level.
4 = One delayed and muted ring signal.
2.16.5
2.16.6
6/1553-ANF 901 54 Uen S2 2016-03-08
Figure 49:
Note: The ring signal can differ depending on the market.
At an incoming call on the free on second line the telephone rings only the first period
and with a low level. This is valid for both the internal and external ring signal.
RINGING OPTIONS
The following ringing options can be programmed on the Line and Monitoring keys:
To change the ringing option, see 10.5 Programming the Ring Signal Type on a Line
or Monitoring Key on page 84 .
RING SIGNAL VOLUME
You can control the ring signal volume by pressing the + key and the - key when the
telephone is idle (no call connected) or when the telephone is ringing.
SILENT RINGING
If the Mute key is pressed while the telephone is idle or when ringing, the tone ringer
will not be activated for the subsequent call(s). The lamp for Line 1 or Line 2 will be
flashing at incoming call. The silent ringing function will be active until you activate a
function in the telephone, for example lift the handset or press a key. To indicate that
the function is active the Mute lamp is lit and the level bar is replaced by the ringer off
icon, see 2.12.2 Display Layout on page 20.
T DBC 425
ELEPHONE
38