Fig. 57: Inserting The Load Bar And Wires Into The Rj45 Plug; Fig. 58: Crimping The Rj45 Plug - Leddar T16 User Manual

7. Insert the load bar inside the RJ45 plug all the way until the wire tips are seated against the inside wall
of the plug housing.

Fig. 57: Inserting the load bar and wires into the RJ45 plug

8. Crimp the connector with the crimp tool.
9. Depress the connector tab and pull the cable until the connector is fully seated inside the plug housing.
10. Hold the plug in position and rotate the cable fitting clockwise until tightened to a torque of 20 lbs-in.
(2 Nm).
11. Install the sensor as described in section "5. Installing the Leddar T16 Sensor."
64 | 72

Fig. 58: Crimping the RJ45 plug

© 2021 LeddarTech Inc.