Connecting The Leddar T16 Sensor; Installing Leddar™ Configuration; Fig. 15: Windows Security Dialog Box - Leddar T16 User Manual

5.2.

Connecting the Leddar T16 Sensor

Once Leddar™ Configuration is installed, you can connect the sensor.
The sensor is in DHCP mode by default.
Refer to Appendix A for the detailed procedure on how to configure the network with either
a static IP or DHCP connection. The module measurement rate varies according to the
oversampling and accumulation settings, and the pulse rate according to FoV
configuration.
6. Installing Leddar™ Configuration
1. Download LeddarInstall.exe via the provided link. Contact LeddarTech at
you did not receive the link.
2. Double-click the file to start the installation.
3. If the Windows Security dialog box opens, click the Install button to accept the installation of the
drivers from LeddarTech during the process.
4. Follow the steps in the Welcome to the Leddar Configuration Software Setup Wizard.
Refer to Appendix A for the detailed procedure on configuring the network with either a static
IP or DHCP connection.
Connecting to Leddar Configuration
To connect your sensor to Leddar Configuration, follow the steps below.
26 | 72

Fig. 15: Windows Security dialog box

support@leddartech.com
© 2021 LeddarTech Inc.
if