Fig. 13: Orienting The "Traffic" Sensor With Reference Marks; Fig. 14: Sensor Position Adjustments - Leddar T16 User Manual

2. Orient the sensor such that the first segment is located on the side of the detection zone and the active
grid (green) is centered in depth with two reference marks (blue circle) you have placed on the side of
the road (see Fig. 13).

Fig. 13: Orienting the "Traffic" sensor with reference marks

The sensor has three position controls: pan, tilt and roll (see Fig. 14).
The pan and tilt are adjustable using the sensor motor ("Traffic" configuration only); the roll can only be
adjusted by hand using the mounting bracket.
These adjustments will vary according to the side of the road on which the sensor is installed.
Refer to section 7.3.1.4 on page 42 for more information on the sensor orientation.
54A0043_V4.0_EN / Leddar T16 – User Guide

Fig. 14: Sensor position adjustments

25 | 72