Part B – Configuring the Network for DHCP Mode
1.
Connect the Ethernet cable (POE+ connection) into the Ethernet port of the sensor and the other end
of the Ethernet cable to your computer or switch. See Fig. 48 below.
2.
In the network connections, make sure that TCP/IPV4 is set to automatic.
Fig. 49: Ethernet properties
3.
Refer to section "6. Installing Leddar™ Configuration" once the configuration is completed.
60 | 72
Fig. 48: Sensor connection to POE+ switch
Fig. 50: IP address and subnet mask
© 2021 LeddarTech Inc.