Fig. 55: Wires In The Load Bar; Fig. 56: Trimming The Wires - Leddar T16 User Manual

4. Cut the wires and insert them in the load bar.
5. Slide the load bar until it sits against the cable jacket, then cut the wires to approximately ¼ in. (5 mm).
6. Trim the remaining wire tips and retract the cable to leave about 1/32 in. (1 mm) of wire.
54A0043_V4.0_EN / Leddar T16 – User Guide

Fig. 55: Wires in the load bar

Fig. 56: Trimming the wires

63 | 72