Connection Details
and Feature
Mode - NAT
7.
Leddar Configuration Software
The Leddar Configuration software allows you to view the detection measurements provided by the
connected sensor. The detections may vary based on the configuration of the parameters.
The main window can be resized manually or set to full-screen view. All dialog boxes that do not include a
selection of action buttons at the bottom, such as Connect, OK or Cancel, are dockable at the top, bottom
or right side of the main window.
When a dialog box or a window is already open, a checkmark appears next to the command on the menu.
When parameters such as the name of the sensor or acquisition settings are modified, a warning message
in red appears in the main window. Click
54A0043_V4.0_EN / Leddar T16 – User Guide
The network address translation (NAT) feature is typically used to access
sensors via the Internet, where the individual sensors share a single public IP
address. To access sensors behind a NAT gateway, prior configuration of the
gateway is required to forward the appropriate ports to the individual sensors.
Up to 10 sensors can be supported.
in the toolbar to save changes.
Fig. 18: Warning message example
Description
29 | 72