Concierge call
If a Guard unit is used in the system, the call to the "Guard unit" can be enabled in the outdoor
stations.
This function can only be used by the outdoor station and the gate station of a building. This
■
function cannot be used by additional outdoor stations that are assigned to a unit as private
outdoor station.
If this function is enabled, each incoming call from this outdoor station will be transferred to
■
the "Guard unit".
For enabling, perform the following points:
Start the operation of the outdoor station as normal, see chapter 6.2.5 "Outdoor station with
■
push-buttons" on page 77.
–
Then perform the following steps:
Fig. 55:
Outdoor station with buttons: Setting the concierge call via the indoor station
1. Enable the "Outdoor station setting / "Concierge call forward" function on the indoor station.
2. Set the physical address for a gate station. A gate station only has the physical address of
the device, see chapter 6.2.1 "Fundamentals of physical addressing ABB-Welcome IP" on
page 63.
–
Address range: 01 - 32
System Manual
Commissioning
│80