Table of Contents
Advertisement
5.4
Indoor stations IP touch: SM installation boxes
Notice
■
■
Fig. 21:
Mounting instruction for the surface-mounting of IP touch
For mounting the surface-mounted installation box, perform the following points:
Fig. 22:
Mounting the installation box: Surface-mounted installation box
1. Align the mounting height between the indoor station, the surface-mounted installation box
and the deep flush-mounted box.
2. Create the boreholes for mounting.
–
The suitable template is enclosed with the box.
–
Dimensional drawings, see chapter 5.9.3 "Installation boxes - Surface mounting" on
page 57.
System Manual
The device is always installed together with the surface-mounted installation
box via a deep standard flush-mounted box.
The mounting height of the device and the deep standard flush-mounted box
should always be aligned so that the cable can be guided through the
surface-mounted installation box without a problem and the device can again
be mounted at the desired height.
Connection, installation / mounting
│42
Advertisement
Table of Contents
