Table of Contents
Advertisement
6.7.3
IP switch actuator
1
2
Fig. 96: Resetting the IP actuator
Resetting becomes necessary, for example, when they have already been integrated in a
system or are to be integrated in a new system.
Carry out the following steps to reset devices:
1. Briefly interrupt the power supply on the device.
–
The device reboots.
–
The LED [1] lights up permanent after the automatic boot up.
2. Press the "Reset" button [2] directly after the permanent lighting of the LED and keep it
pressed.
–
The LED [1] flashes fast several times after 3 seconds. Then keep the "Reset" button [2]
pressed until the LED [1] stops flashing and lights up permanently again.
–
The existing data are reset.
3. Loosen the "Reset" button [2].
–
The LED [1] goes out.
–
The device reboots.
System Manual
Commissioning
│119
Advertisement
Table of Contents
