Ip Actuator Settings; Ip Actuator Enters Engineering Mode; Accessing The "Ip Actuator Settings" Screen - ABB Welcome IP H8236 Series Product Manual

8.10

IP actuator settings

8.10.1

IP actuator enters Engineering mode

Note
The IP actuator must enter engineering mode before use.
Pressing the reset button of the IP actuator once when it works normally, the LED flashing
green means that the IP actuator has entered engineering mode.
8.10.2

Accessing the "IP actuator settings" screen

On the "Engineering setting" screen on the IP touch, tap "IP actuator settings" to access the
corresponding screen.
Tip
The IP actuator will exit engineering mode if no operation is carried out for 5
minutes.
Product manual 2TMD041800D0002
Commissioning
│192