HEIDENHAIN TNC 620 User Manual page 493

Tables and overviews | Machine-specific user parameters
Parameter settings
DisplaySettings
Settings for screen display
Display sequence and rules for axes
[0] to [7]: depends on the available axes
Key name of an object in CfgAxis
Key name of the axis to be displayed
Axis designation
Axis designation to be used in place of the key name
Display rule for the axis
ShowAlways
IfKinem
IfKinemAxis
IfNotKinemAxis
Never
Display sequence and rules for axes in the REF display
[0] to [7]: depends on the available axes
See display sequence and rules for axes
Type of position display in the position window
NOML
ACTL
REF ACTL
REF NOML
LAG
ACTDST
REFDST
M118
Type of position display in the status display
NOML
ACTL
REF ACTL
REF NOML
LAG
ACTDST
REFDST
M118
Definition of decimal separator for position display
. point
, comma
Display of the feed rate in the Manual Operation and El. Handwheel modes of operation
at axis key: Display the feed rate only if axis-direction key is pressed
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
12
493