Calling Tool Management - HEIDENHAIN TNC 620 User Manual

Tools | Tool management

Calling tool management

Refer to your machine manual.
The procedure for calling the tool management may
differ from that described below.
Select the tool table: Press the TOOL TABLE soft
key
Scroll through the soft-key row
Press the TOOL MANAGEMENT soft key
The control switches to the new table view.
Tool management view
In the new view, the control presents all tool information in the
following four tabs:
Tools: Tool-specific information
pockets: Pocket-specific information
The Expanded Tool Management (option 93) additionally provides:
Tooling list: List of all tools in the NC program that is selected in
the Program Run mode (only if you have already created a tool
usage file)
Further information: "Tool usage test", Page 145
T usage order: List of the sequence of all tools that are inserted
in the NC program selected in the Program Run mode (only if you
have already created a tool usage file)
Further information: "Tool usage test", Page 145
If a pallet table is selected in the Program Run operating
mode, the Tooling list and T usage order are calculated
for the entire pallet table.
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
4
151