5
Features in the program run modes of operation
You can use the following functions in the Program Run modes of
operation:
The NC Start key (NC Start handwheel key)
The NC Stop key (NC Stop handwheel key)
After the NC Stop key has been pressed: Internal stop (handwheel
soft keys MOP and then Stop)
After the NC STOP key has been pressed: Traverse manual axes
(handwheel soft keys MOP and then MAN)
Returning to the contour after the axes were moved manually
during a program interruption (MOP and then REPO handwheel
soft keys). The handwheel soft keys, which function similarly to
the screen soft keys, are used for operating.
Further information: "Returning to the contour", Page 289
On/off switch for the Tilt working plane function (handwheel soft
keys MOP and then 3D)
182
HEIDENHAIN | TNC 620 | User's Manual for Setup, Testing and Running NC Programs | 01/2022
Setup | Moving the machine axes