Table of Contents
Advertisement
Avanti Stove (DV & B-Vent) Blower Removal
Warning
Make sure the power cord is disconnected prior to conducting service.
Warning
Shut off gas to the heater - you may need to disconnect the gas line
depending upon the heater location and the type of gas connection.
1
Remove the rear panel.
Molex
Connection
2
Disconnect the side panels from the baseplate.
Slide the side and top panels up and prop them
in place to access the blower area.
3
With the left rear of the heater exposed, the
blower assembly can be accessed. Follow the
directions on page 5-5 (A20 Blower Assembly
Removal & Disassembly) to remove the blower
from the heater.
Travis Industries
Blower Components
Disconnect the molex connector
leading from the power cord.
Gas T-Shoot Guide
Disconnect the wires leading
to the on/off switch.
Rear Panel
Remove
the strain
relief
Use a 2x4
to prop up
the top and
sides.
5 - 1
Standard
Screwdriver
19203
Advertisement
Table of Contents
Troubleshooting
