Pilot Orifice Removal - Travis Industries Spirit 300 GS Service Manual

Burner Pan Components

Pilot Orifice Removal

Warning: The pilot tube connections are a common location for gas leaks.
special care on these gas connections and leak test at both connections
after
1996 or Earlier Burners
The burner pan must be remoed prior to
removing the pilot orifice. Disconnect the
compression nut with a 7/16" open end
wrench and move the pilot tube away from the
pilot assembly (see ÒPilot Assembly RemovalÓ
on page 4-7). You may need to tap the burner
pan to dislodge the pilot orifice.
Pilot Tube Port
on Pilot Assembly
Pilot Orifice
Pilot Tube
Compression Sleeve
Compression Nut
NG vs. LP Orifice
Travis Industries
installing.
Make sure the pilot
tube inserts into the
pilot orifice.
LP Pilot
Orifice
L
1 6
P
Gas T-Shoot Guide
1997 or Later Burners
Disconnect the compression nut with a 7/16"
open end wrench and move the pilot tube
away from the pilot assembly (see ÒPilot
Assembly RemovalÓ on page 4-8).
Pilot
Assembly
Pilot Tube Port
on Pilot Assembly
Pilot Orifice
Compression
Sleeve
Compression
Nut
Pilot Tube
NG Pilot
Orifice
2 1
N
4 - 9
Take
Make sure the
pilot orifice fits
over the
compression
sleeve.
19203