Heritage Bay Stove Blower Removal - Travis Industries Spirit 300 GS Service Manual

5 - 10
Heritage Bay Blower Removal
Warning Make sure the power cord is disconnected prior to conducting service.
Warning Shut off gas to the heater - you may need to disconnect the gas line
depending upon the heater location and the type of gas connection.
1 Remove the four nuts underneath the
blower.
Remove these nuts
3 Disconnect the wires from the blower.
Travis Industries
Blower Components
Gas T-Shoot Guide
2 Slide the blower assembly out. You may
wish to remove the stud bracket and
rubber grommets from the blower
assembly to better facilitate removal.
Blower Assembly
Stud Bracket
4 When re-installing, make sure the grommet
slides into make sure the stud bracket is
fed through from above with a washer
between it and the rubber grommet.
The blower
assembly inserts
into this groove.
Stud
Bracket
Rubber
Grommet
Washer
Nut
19203