Dvs Insert And Dvs Fireplace - Travis Industries Spirit 300 GS Service Manual

3 - 8

DVS Insert and DVS Fireplace

Lopi Discovery - remove the door by lifting it up and away from the face.
Avanti DVS - remove the door by lifting it up and away from the face.
FPX 32 - use a phillips-head screwdriver to remove the four screws holding it in place.
The glass is removed following the directions below.
Removing the Glass
a
Loosen the nuts on the
top and side glass clips
until they are flush with
the end of the stud (do
not remove the nuts).
While holding the glass, slide the
b
side and top glass clips off.
c
While holding the glass,
loosen the nuts on the
bottom glass clip until
they are flush with the
end of the stud. Pivot
the glass forward and
remove.
Glass Clip
Attachment Studs
Face of Heater
Glass Gasket
(3/4" self-adhesive
channel gasket)
Travis Industries
Door & Glass Removal
Cross Section of
Glass Attachment
Glass Clip Nuts
Glass Clip
Glass
Gas T-Shoot Guide
Replacing the Glass
a
With the bottom glass clip in place and
the nuts flush with the end of the stud,
position the glass over the bottom clip
(do not tighten the nuts).
b
Replace the top glass clip
(do not tighten nuts).
d
Tighten the nuts on the
bottom glass clip first, then
the top, then the sides.
c
Center the glass then
replace the side glass clips
(do not tighten nuts).
19203