Dvs Insert Blower Removal - Travis Industries Spirit 300 GS Service Manual

5 - 6

DVS Insert Blower Removal

Warning Make sure the power cord is
disconnected prior to
conducting
Warning Shut off all gas and
disconnect the gas line from
the
1 Remove the insert from the fireplace
(remove the panels, glass and logs first to
prevent damage while moving the insert).
2 To disonnect the vent, disconnect the
manifold from the heater (see the illustration
to the right).
3 Remove the left side cover plate (see the
illustration below to the left).
4 Remove the four nuts holding the blower in
place. Then remove the stud plate behind
the blower on the right side (see the
illustration below to the right).
These nuts hold the blower
assembly in place.
5 Slide the blower to the left, disconnect the
electrical connection, then slide the blower
out.
Travis Industries
Blower Components
service.
heater.
Remove the three
screws holding the
plate in place.
Gas T-Shoot Guide
Convection Top
Remove the three screws holding
the convection top to the insert.
Remove the four bolts
inside the firebox.
7/16Ó
Socket
NOTE: when installing the
manifold, make sure the
gaskets sealing the inlet and
exhaust ducts are in place. If
a gasket is loose, use high-
temperature silicone to
secure it to the manifold.
11/32" Nutdriver
Slide the blower out to the side.
6 When re-installing, make sure to position
the brackets correctly behind the blower
assembly.
Mounting Plate
Nut
Washer
Manifold
Slide the
manifold
back.
Shim the manifold legs if
installing into a fireplace
with a raised hearth.
Remove the four nuts
holding the blower in place.
on Heater
Blower
Plate
Rubber
Grommet
& Bushing
Stud
Plate
19203