Equipment Safety Instructions - Vatech Smart Plus PHT-35LHS Technical Manual

3. Equipment Safety Instructions

This electro-medical device contains high voltage and current flowed parts, and the following
instruction must be followed to avoid critical damage to the body and equipment.
Electrical Safety Caution
Mechanical Safety Caution
.
VT-TECH-Smart Plus-001
The equipment and PC should be connected to a common protective

earth. Confirm that the equipment is well-grounded.
High voltage and current flows throw equipment. Turn off equipment

power and wait at least 2 minutes before the operation begins.
Do not connect this equipment to any devices without authorization from

Vatech. Inc.
Do not connect this equipment to a Multiple Portable Socket- Outlet

(MPSO) or extension wires
Keep in mind that MCU boards are electrically sensitive that operators

need to wear shielding gloves during operation.
The only part that can be replaced by the users is the input fuses. Check

if the fuses comply with the manufacturer's specifications.
Ensure that your fingers or any part of your body are shut in the

equipment.
Press the emergency stop button to stop the equipment when a problem

occurs during the operation. The equipment will be cut off from the
power as you press the button.
Do not touch the patient while touching the SIP or SOP connector.

Ensure that the patient's eyes directly contact the laser beam when you

are guiding his or her position.
Never expose the equipment to liquids, mists, or sprays. They can

cause electrical accidents such as an electric shock or system damage.
Do not use spray cleaners on the equipment to avoid fire.

Do not use solvent aerosol or spray cleaning agents directly on the

surface of the equipment. It can damage equipment including the LCD
panel.
7 / 188
Smart Plus (PHT-35LHS)
Technical Manual
COPYRIGHT© 2018 VATECH
.
ALL RIGHTS RESERVED