Equipment Safety Instructions - Vatech A9 Technical Manual

Equipment Safety Instructions

This electro-medical device contains high voltage and current flowed parts, and the following
instructions must be followed to avoid critical damage to the body and equipment.
VDH-TeM-098
Electrical Safety Caution
• The equipment and PC should be connected to a common
protective earth. Confirm that the equipment is well-grounded.
• High voltage and current flows throw equipment. Turn off
equipment power and wait at least 2 minutes before the operation
begins.
• Do not connect this equipment to any device without authorization
from VATECH Co., Ltd.
• Do not connect this equipment to a Multiple Portable Socket- Outlet
(MPSO) or extension wires
• Keep in mind that MCU boards are electrically sensitive that
operators need to wear shielding gloves while operating.
• The only part that can be replaced by the users is the input fuses.
Check if the fuses comply with the manufacturer's specifications.
Mechanical Safety Caution
• Be aware that fingers or parts of your body are not shut in the
equipment.
• If a problem occurs during operation, immediately press the red
emergency stop button to stop equipment operation and cut off all
power to the equipment.
• Never touch the patient while touching the connector of SIP/SOP.
• While adjusting the patient, ensure that the laser beam is not
directed at the patient's eyes.
• Never expose the equipment to liquids, mists, or sprays. Any liquid
may cause an electrical shock or otherwise damage the system.
• Do not use spray cleaners on the equipment to avoid fire.
• Do not use solvent aerosol or spray cleaning agents directly on the
surface of the equipment. It can damage equipment, including the
LCD panel.
10 / 214
Vatech A9 (PHT-30CSS)
Technical manual
COPYRIGHT© 2020 VATECH
.
ALL RIGHTS RESERVED