Hardi ALPHA EVO EcoDrive 5100 Instruction Book page 89

Defe cts in the ope ration
Defects in the operation may be caused by:
• A forward speed out of the required speed range, while changing the track.
• One or more wheels have not reached their position after 30 seconds (rut, me chanical, hydr aulic or electronic defaults).
In the se cases, the status indicator (1) flashes. To cance l errors:
• Press and hold (4) for 2 seconds.
• Press the button (3) or (5) briefly to reset the syste m.
μ
ATTENTION: If the re se t procedure fails, the control unit must be turned off.
Limp Mode
Limp mode appe ars if an angular sensor is defective., A red light (1) comes on
Only the retracting of the track width is authorized, but the ends stop are not dete cted
• Drive the machine between 2 to 12 kph.
• Press and hold the button (3 ) for controlling the track width
For maintenance see "Hydraulic Track Axle" page 203
5 - Operation
2.20
9
0
2.20
9
0
89