Support Leg; Jack Up The Sprayer - Hardi NAVIGATOR VPZ Instruction Book

4 - Sprayer Setup

Support Leg

The support leg is stored in the bracket on the sprayer's right side when
the sprayer is attached to the tractor.
To Use the Support Leg
1. Lift the leg off the storage bracket.
2. The support leg can then be mounted on the drawbar on both
sides as preferred (for high hitch, left side only).
3. Secure with the linchpin.
To Remove the Support Leg
1. Lift the leg.
2. Remove the linchpin and pull out the support leg.
3. Secure the leg at the storage bracket with the linchpin.

Jack Up the Sprayer

When the sprayer needs wheel mounting or changing of wheels, wheel
bearings or brakes, jack up the sprayer under the axle as shown.
Notice the axle load (kg) in "Tyre Pressure" on page 191, and use a
suitable jack and suitable support stands for the task.
€
DANGER! Be sure to place sprayer at level and firm ground to
prevent the sprayer from falling down from the jack. For your
safety:
• use chocks at the opposite wheel to prevent rolling.
• connect the sprayer's drawbar to a tractor to help balance
the sprayer on the jack.
• place strong support stands below the wheel axle, once it is
jacked up. The jack alone is only for lifting and lowering the
sprayer.
74