Filling Powder Chemicals Using The Turbofiller (Manual Version) - Hardi NAVIGATOR VPZ Instruction Book

8. If the chemical container is empty, it can be rinsed by the "chemical
container cleaning device". Place the container over the multi-hole
nozzle and press the lever to activate container cleaning.
€
DANGER! In order to avoid spray liquid hitting the operator, do
not press the lever, unless the multi-hole nozzle is covered by a
container, as spray liquid may otherwise hit the operator!
μ
ATTENTION! The rinsing device uses spray liquid to rinse
containers for concentrated chemicals. Before disposal, always rinse the chemical containers with clean water several
times, until they are clean.
9. Flush the TurboFiller with clean water by pressing
an external tank. The TurboFiller suction valve must be open for at least 20 seconds after the rinse water is no longer
visible in the hopper, in order to empty the transfer hoses completely into the MainTank.
μ
ATTENTION! If the suction SmartValve is not shifted to suction from a clean water supply, the hopper rinsing device
uses spray liquid for rinsing the hopper! Cleaning the TurboFiller must always be done, when the spray job is ended,
and together with cleaning the entire sprayer. A cleaning after the last filling, and before spraying, does not ensure a
clean TurboFiller!
10. Close the TurboFiller suction valve, when the hopper has been rinsed. Close the lid.
11. Press
to turn On agitation, or enable AutoAgitation in the
controller.
μ
ATTENTION! If foaming is a problem, reduce the agitation.
12. When the spray liquid is well agitated, press
pressure SmartValve towards "spraying" position. Continue
agitation during spraying of the crop.

Filling Powder Chemicals Using the TurboFiller (Manual Version)

1. Fill the MainTank at least 1/2 with water (unless otherwise stated
on the chemical container label). See section "Filling of water".
2. Turn the handle of the suction SmartValve towards "MainTank".
3. Turn the pressure SmartValve towards "Pressure
draining/TurboFiller".
4. Turn the agitation valve towards "agitation" as required:
• A fully open agitation valve will result in very little suction
from the TurboFiller.
• A fully closed agitation valve will result in no agitation, while
the powder is being transferred into the tank, resulting in
poor mixing.
μ
ATTENTION! For increased suction from the TurboFiller the agitation valve can be kept closed.
μ
ATTENTION! If filling water from an external tank, this can be continued while doing the next steps.
€
DANGER! Before turning the pressure SmartValve to "Pressure draining/TurboFiller" it is very important to be sure that
the quick coupler lid is correct and completely fitted to the filling stud into its locked position. Failure to do so may
for suction from the RinseTank or press
to turn the
5 - Operation
for suction from
111