Horizontal Alignment Of The Centre Section And Inner Wing; Horizontal Alignment Of The Inner Wing And Outer Wing; Vertical Alignment Of The Inner Wing And Outer Wing - Hardi NAVIGATOR VPZ Instruction Book

6 - Maintenance

Horizontal Alignment of the Centre Section and Inner Wing

1. Loosen the nut (A).
2. Adjust the screw (B) with an Allen key. There should be 10 mm
thread visible on the outside of the nut (A).
3. Tighten the nut (A) against the plate again.

Horizontal Alignment of the Inner Wing and Outer Wing

μ
ATTENTION! This alignment must be done before attempting to
do the "Over-Centre Boom Lock Adjustment" on page 164.
÷
NOTE! This instruction applies for the connection between inner
and outer wing as well as for 1 and 2 outer wing.
1. Loosen the lock nuts (A).
2. Adjust the screws (B).
3. Tighten the lock nuts (A).
4. Fold the boom to see if it hits and rests correctly in the transport
brackets.

Vertical Alignment of the Inner Wing and Outer Wing

μ
ATTENTION! This alignment must be done before attempting to
do the "Over-Centre Boom Lock Adjustment" on page 164.
Furthermore, always follow up this alignment with the "Over-
Centre Boom Lock Adjustment" on page 164.
÷
NOTE! This instruction applies for the connection between the
inner and outer wing as well as for 1st and 2nd outer wing.
1. Unfold the boom.
2. Slightly loosen the nuts (A) and (C).
3. Begin with turning the eccentric bolts (B) and (D), so that their
punch mark in the side of the bolt head points towards the
breakaway section on the boom.
162