Support Leg; Jack Up The Sprayer - Hardi NAVIGATOR PRO Original Instruction Book

4 - Sprayer setup

Support leg

The support leg is stored in the bracket on the sprayer's right side when
the sprayer is attached to the tractor.
To use the support leg
1. Lift the leg off the storage bracket.
2. The support leg can then be mounted to the drawbar extension
on both sides as preferred (high hitch left side only).
3. Secure with the linch pin.
To remove the support leg
1. Lift the leg.
2. Remove the linch pin and pull out the support leg.
Secure the leg at the storage bracket with the linch pin.

Jack up the sprayer

When the sprayer needs wheel mounting, wheel changing, brake or
wheel bearing changing etc. then jack up the sprayer under the axle as
shown.
€
DANGER! Be sure to place sprayer at level and firm ground to
avoid sprayer falling down from the jack.
μ
ATTENTION! It is good practice to use stop wedges at the
opposite wheel!
34