Anti-Yaw Mechanism - Hardi NAVIGATOR VPZ Instruction Book

Anti-Yaw Mechanism

The boom is equipped with cone-shaped rubber dampers for damping
the yaw movements when driving in the field.
The level of damping can be adjusted if necessary by re-locating the
spacer plates (C). No specific adjustment requirements can be given, as
this may vary with local driving conditions.
1. Loosen the bolt (B).
2. Remove the Allen screw (A).
3. Remove one or more spacer plates from the storage position.
4. Push the rubber damper away from the bracket and place the
spacer plate(s) between the damper and bracket (D).
5. Refit the Allen screw (A) so that it passes through the hole in all the
spacer plates.
6. Tighten the bolt (B) again.
7. Repeat step 1 to 6 for the other boom wing.
4 - Sprayer Setup
89