Siemens 8DJH Installation And Operating Instructions Manual page 84

7 | Installation
84/174
4. Hook the busbar termination cover into the clamping plate at the top, and fasten it
(tightening torque: 30 Nm).
Fig. 90: Hooking in the busbar termination
cover
Busbar termination cover
1
Bolt-and-washer assembly M8x30
2
Nut-and-washer assembly M8
3
5. Insert the cap into the opening of the side wall.
Mounting the closure plate
If the panel was not originally supplied as an end panel, a closure plate must be mounted on the
side walls in the cable compartment.
1. If an earthing point is mounted on the side wall: Remove the earthing point
2. Fasten the closure plate
position of the closure plate (see arrow).
3. Mount the removed earthing point
Fig. 92: Closure plate with earthing point
1 Closure plate
2 Earthing point
3 Blind rivet M5x12
Completing installation
1. Depending on the position of the end panel, close the openings with sealing stoppers or
bolt-and-washer assemblies.
8DJH • Installation and Operating Instructions • Version 11 • 500-8384.9
Fig. 91: Mounting the busbar termination
cover
Cap
1
to the side wall using 2 blind rivets
1
again at the same position on the closure plate.
2
Fig. 93: Closure plate at the panel with
earthing busbar
.
2
. Observe the mounting
3