Mellanox Technologies MTS3610 Installation Manual page 5

MTS3610 Installation Guide
Step 8. Tighten all eight bolts into the caged nuts.
Inserting the Chassis
Step 1. Screw the four Eye bolts to the four corners of the top of the chassis.
Step 2. Connect the eye bolts to a Mechanical lifting device.
Step 3. Raise the chassis 2 cm (1") above the level of the shelf.
Step 4. Move the chassis over the shelf. Place the chassis so that the face plate of the chassis
is a few inches from the vertical rack support.
Step 5. Lower the chassis onto the shelf.
Step 6. Remove the mechanical lifting device.
Step 7. Place ten caged nuts into the vertical rack support at the locations corresponding to
the holes in the chassis faceplate.
Rev 1.2.2
Figure 6: Shelf Installation
Figure 7: Mechanical Lifting Device
Mellanox Technologies
5