Mellanox Technologies MTS3610 Installation Manual page 11

MTS3610 Installation Guide
Table 2 - Configuration Wizard Session (Sheet 2 of 2)
You have entered the following
information:
1. Hostname: <hostname>
2. Use DHCP on eth0 interface? :
yes
3. Admin password (Enter to leave
To change an answer, enter the step
number to return to.
Otherwise hit <enter> to save
changes and exit.
Choice: <Enter>
Configuration changes saved.
To return to the wizard from the
CLI, enter the "configuration jump-
start" command from configuration
mode. Launching CLI...
switch-1 >
Step 5. Before attempting a remote (for example, SSH) connection to the switch, check the
eth0 interface configuration. Specifically, verify the existence of an IP address. To
check the current eth0 configuration, enter the following commands:
switch-1 > enable
switch-1
The following is an example of the output:
Interface eth0 state
Admin up:
Link up:
IP address:
Netmask:
Speed:
Duplex:
Interface type:
Interface source:
MTU:
HW address:
Comment:
RX bytes:
RX packets:
RX mcast packets:
RX discards:
RX errors:
RX overruns:
RX frame:
TX bytes:
TX packets:
TX discards:
TX errors:
TX overruns:
TX carrier:
Rev 1.2.2
Wizard Session Display (Example)
unchanged): (CHANGED)
# show interface eth0
yes
yes
192.168.10.6
255.255.255.0
100Mb/s (auto)
full (auto)
ethernet
physical
1500
00:00:50:3A:8E:80
123102
1271
0
0
0
0
0
122850
1119
0
0
0
0
Mellanox Technologies
Comments
The wizard displays a summary of your
choices and then asks you to confirm the
choices or to re-edit them.
Either press <Enter> to save changes and
exit, or enter the configuration step number
(1, 2 or 3) that you wish to return to.
// Enter 'enable' mode of CLI
// # indicates 'enable' mode
11