Ac Input Power Only - Maximum Controls MAX ARM Installation And Owner's Manual

3

ac input power ONLY

NOTE: IF solar power is being installed, see page 38.
Choose either 115V or 230V setting on input AC power selector switch.
Wire desired input AC power wire to power terminal.
Input AC Power Options
CAUTION: If input AC power selector
switch is set for 115V but input power
is actually 230 V, 7 Amp Fuse will blow.
Single Phase 115VAC Only
115VAC
Set to 115V
115 OR 230VAC
Input AC Power Wire
Single Phase 230VAC Only
230VAC
Set to 230V
Turn Power ON
AVERTISSEMENT: pour ne pas compromettre la
protection contre les risques d'incendie, utiliser un
fusible de mêmes type et caractéristiques nominales.
WARNING: For continued protection
against fire, replace only with the
same type and rating of fuse.
115VAC
3A max
LEDs should light up on DSP board.
Battery power automatically turns ON.
MAX Arm/Ultra Arm V1
DANGER
HIGH VOLTAGE!
Power Terminal
Line (Black)
Neutral (White)
Chassis (Green)
IMPORTANT: Make sure there are NO exposed
bare wires at the power terminal connection.
7A
FUSE
On Select Input Voltage
115VAC or 230VAC
Off
POWER IMPORTANT:
POWER IN
must be followed whenever ALL
(AC)
power must be turned OFF.
CAUTION:
breaker is OFF from incoming
AC input wire BEFORE wiring!
(located inside of control box)
AC Power Selector Switch
AVERTISSEMENT: pour ne pas compromettre la
protection contre les risques d'incendie, utiliser un
fusible de mêmes type et caractéristiques nominales.
Line (Black)
Neutral (White)
Chassis (Green)
Turn Power OFF
AVERTISSEMENT: pour ne pas compromettre la
protection contre les risques d'incendie, utiliser un
fusible de mêmes type et caractéristiques nominales.
1 Turn OFF POWER Switch on MAX Toroid Box.
Battery power will remain ON.
This procedure
2 Press and HOLD the RED ON/OFF
BATTERY button on DSP board until
beep is heard, then release button.
Make sure circuit
MAX Toroid Box
7 Amp Fuse
WARNING: For continued protection
7A
against fire, replace only with the
FUSE
same type and rating of fuse.
On
Select Input Voltage
115VAC or 230VAC
Off
POWER
115VAC
POWER IN
3A max
(AC)
WARNING: For continued protection
7A
against fire, replace only with the
FUSE
same type and rating of fuse.
On Select Input Voltage
115VAC or 230VAC
Off
POWER
115VAC
POWER IN
3A max
(AC)
ON/OFF
BATTERY
19