Rtn - Javad HPT404BT Operator's Manual

TEMP =29
SYNC =0
MODE =FIXED
VHPA =11.71 V
BT =OFF

6. RTN

Command RTN is used to select, configure, control and monitor the active Real Time Network. Except
the monitoring parameters (STATE and ERROR) all the parameters of RTN services can be saved in the
user configuration file by SAVE command.
Parameter Name
TYPE
CONNECT
HOSTNAME
HOSTPORT
www.javad.com
Sets/gets the active RTN service:
0 – TCP client;
1 – NTRIP client;
2 – TCP server.
Example: the next command selects NTRIP client as an active RTN service to be
configured, controlled and monitored:
RTN TYPE 1
The next command is used to get currently selected active RTN service:
RTN TYPE
1
@00
Starts/stops the active RTN service.
0 – Stops/disconnects the active RTN service if it is running;
1 – Starts/connects the active RTN service if it is stopped.
There is a 50-70 seconds and 15 seconds timeouts for start and stop processes
correspondingly. If during this timeout the start/stop operation is not succeeded the
operation is failed and the last error is monitored by RTN ERROR command.
Example: the next command starts the active RTN service:
RTN CONNECT 1
Sets/gets the string type value representing the host name/IP address of the active RTN
service. In case of TCP/NTRIP clients this is the IP address/host name of the remote
machine to connect. In case of TCP server this parameter is read only and represents its
own IP address assigned by GPRS network.
<value> – string (length < 64 bytes).
Example: next command sets the IP address of the host to connect
RTN HOSTNAME 92.43.102.1
Next command gets the currently set IP address of the active RTN:
RTN HOSTNAME
92.43.102.1
@00
Sets/gets the decimal numeric value representing the host port of the active RTN service.
In case of TCP/NTRIP clients this is the port of remote machine to connect. For TCP
server this is the port on which the server is listening for incoming connections.
<value> - port number (1..65535).
Example: next command sets the host port of active RTN service:
RTN HOSTPORT 3615
Next command gets the currently set host port of the active RTN service:
RTN HOSTPORT
3615
@00
Description and parameters list
Command Line Interface
RTN
39