Page 1
HPT404BT JL User Manual Version 1.0 Last revised July 25, 2018 All contents in this manual are copyrighted by JAVAD GNSS. All rights reserved. The informa- tion contained herein may not be used, accessed, copied, stored, dis- played, sold, modified, published,...
OR REVENUE, OR LOSS OF THE PRODUCT’S sent and may only use such information for USE. IN ADDITION, JAVAD GNSS IS NOT RE- the care and operation of your HPT404BT JL. SPONSIBLE OR LIABLE FOR DAMAGES OR The information and data in this Manual are...
Software under the terms stated herein ranty and limitation of liability). and in any case only with a single HPT404BT SAFETY – Improper use of HPT404BT JL can JL or single computer. You may not assign or lead to injury to persons or property and/or transfer the Software or this license without malfunction of the product.
Alter- dustry Canada technical specifications were natively, request technical support using the met. JAVAD GNSS World Wide Web site at: www. WEEE Directive javad.com To contact JAVAD GNSS Customer Support The following information is for EU-mem-...
The table below describes the LED indicators ing the field GNSS equipment to RTN, where no and device state: cell phone cover is available. HPT404BT JL de- vices may contain 4 W UHF (406 to 470 MHz) Figure 1. LED indication...
2. Connect HPT404BT JL to external power have an output rated for +9 ... +36V, 4A. This supply (10…30 V). may not be the same range as other JAVAD 3. Insert optional SIM card and SD card to the GNSS products with which you are familiar.
NMO interface with PAN profile support. HPT- • UHF Antenna 455-460 MHz, 5/8, 5 dBd 404BT JL Bluetooth-interface is in visibility gain, NMO mode, has the name “HPT404BT JL” and PIN • UHF Antenna 460-465 MHz, 5/8, 5 dBd...
Page 8
10.1.11.1:8080. • via WiFi interface: The device (PC, handheld/pad) should be with WiFi inter- face. HPT404BT JL WiFi-interface has the name “HPT404BT JL” and password “test- test”. When connection is established open the web-browser and enter the address 10.1.10.1:8080.
Page 9
“jlinklte” as password. For connecting port CLI interface with user name “jlink” to HPT404BT JL serial port needed to setup password “jLTEXXXXX” where “XXXXX” is with following parameters: serial number of device which is written in •...
Page 10
HPT404BT JL: Wait for registering in the network and Inter- net access availability . Detailed connection 1. Connect to HPT404BT JL via web interface status you can check in Status/GSM tab. as described above. 2. Configure the Cellular (GSM ): In the Communication/GSM tab set the PIN code and APN parameters (if necessary);...
Page 11
4. Reboot device. In the Administration/ Management tab click “Reboot” button and wait until reboot. Figure 14. HPT404BT JL NTRIP Data Router tab 6. Setup NTRIP Client. In the Services/NTRIP tab set following parameters: “Server name/ address”, “Port”, “User” , “Password” .
Page 12
UHF channel (in Satel mode) to Serial Port The following are the steps of configuration of HPT404BT JL: 1. Connect to HPT404BT JL via web interface as described above. 2. UHF configuration in Satel mode: In the Communication/UHF Int. tab: •...
Page 13
5. Setup Router In the Setup/Router tab select following pa- rameters “UHF Modem” as Source and “Se- Figure 19. HPT404BT JL UHF Int. Status tab rial port“ as Destination. 3. Setup Serial Port Click “Save Setting” button and wait until In the Communication/Advanced tab select finish.
Page 14
The following are the steps of configuration of HPT404BT JL: Figure 22. HPT404BT JL UHF Modem Router 1. Connect to HPT404BT JL via web interface. 6. Connect Serial Port 2. GSM configuration: Use any application to connect serial port of...
Page 15
Gateway (e.g, 10.1.10.1), and WLAN Net- work Mask (e.g, 255.255.255.0). Set the AccessPoint parameters: WLAN Ac- cess Point ID (enter SSID of HPT404BT JL), WLAN AP mode(wpa). Set the WPA parameter: WLAN WPA Pass- Figure 24. HPT404BT JL WiFi configuration tab...
Page 16
Figure 27. NetView WLAN configuration tab After restarting the device you can check the WiFi connection in the web interface Status/ WiFi tab of HPT404BT JL. Figure 28. HPT404BT JL WiFi status tab Now TRIUMPH-2 can provide the services trough the Internet by 1120-1125 port.
SPECIFICATIONS UHF Radio Transmitter Specification Parameter Specification Parameter Specification Operating Frequen- Output Power 15 dBm to 36 dBm in 1 dB steps (32mW to 4W) 406 - 470 MHz (EU) cy Range USA, Canada 15 dBm to 33 dBm in 1 dB steps (32mW to 2W) 406.1 - 470 MHz (USA) 406.1 - 430;...
Page 19
Variant 2: 4 W UHF Transceiver, 4G Bluetooth, WiFi, Ethernet, USB and cellular data module, GNSS receiv- Serial port. er, Bluetooth, WiFi, Ethernet, USB and Serial port. Pinout of HPT404BT JL power and com- munication port SIGNAL DESCRIPTION TX+/RTS_ Transmit Data positive line (RS-422) /...
Unplug this apparatus during lightning storms • The HPT404BT JL receiver should nev- or when unused for long periods of time. er be used in dangerous environments. Use in rain or snow for a limited period is permitted.
Dealers. accompany the package furnishing a descrip- tion of the problem and/or defect. During the warranty period, JAVAD GNSS will, at its option, repair or replace this prod- The purchaser’s sole remedy shall be replace- uct at no additional charge. Repair parts and ment as provided above.
Need help?
Do you have a question about the HPT404BT JL and is the answer not in the manual?
Questions and answers